Motorcycle/ATV Jacks and Lifts
by J. Rex Brown

Working on a motorcycle is something most riders enjoy. But some jobs can be a real pain if your bike doesn't have a center stand or you need raise the front end. For these jobs a real motorcycle jack is the best bet.

Omega's jack will lift up to 1500 pounds of bike or ATV over 16 inches off the garage floor. The jack is wide enough to keep things stable even if you have to use the "hammer wrench" on stubborn axle nuts.

• Safety lock mechanism for safe support
• Rubber padded lifting platform- prevents scratching and protects your frame
• Non-slip foot pedal allows for easy lifting
• Foot pedal operated hydraulic unit
• Tie down strap

I shopped around and was about to buy a cheapie from our local China Wholesale tool store. After comparing the quality it changed my mind. Besides, what's the point of saving a few sawbucks if you drop your pride and joy? Or worse yet, injure yourself?

Available online from Motorcycle USA and JC Whitney

Or maybe you're looking for the Ultimate in motorcycle lifts? Check out this 1000 lb. capacity air operated work platform. Too cool!

Servicing and detailing a motorcycle has never been easier. This allows you to effortlessly position, secure and lift bikes up to 1,000 lbs using 100 psi shop air pressure through the convenience of a foot valve controller. Lifts to a full 31" and features the ability to lock into position at 24", 26", 28" or 30" lifting height. The platform is 2 feet wide and over 8 feet long to accommodate street bikes, dirt bikes, and even ATV's and Three Wheelers.

Available online from Eastwood Tools

Maybe you're looking for something a little more basic? Well, they don't get any easier than the Quad Stick. Just run it up underneath your four-wheeler and heave.

It's intended to go under the swingarm. But we've seen some enterprising bubba's using it to lift any corner of their ATV.

Available online from Ride Gear

Labels: review

Posted by Rex Brown
Link: to this article